- CONNECT TO PPTP VPN MAC COMMAND LINE HOW TO
- CONNECT TO PPTP VPN MAC COMMAND LINE SOFTWARE
- CONNECT TO PPTP VPN MAC COMMAND LINE WINDOWS
Service timestamps debug datetime msec localtime
!- Enable virtual private dial-up networking.Ģ621(config)# vpdn enable !- Enters VPDN group configuration mode for the specified VPDN group.Ģ621(config)# vpdn-group 1 !- Enters VPDN accept-dialin configuration mode !- and enables the router to accept dial-in requests.Ģ621(config-vpdn)# accept-dialin !- Specifies which PPTP protocol is used.Ģ621(config-vpdn-acc-in)# protocol pptp !- Specifies the virtual template that is used !- in order to clone the virtual access interface.Ģ621(config-vpdn-acc-in)# virtual-template 1Ģ621(config)# ip local pool test 192.168.1.1 192.168.1.250 !- Create virtual-template interface used for cloning !- virtual-access interfaces with the use of address pool test !- with Challenge Authentication Protocol (CHAP) authentication, PAP, and MS-CHAP.Ģ621(config)# interface virtual-template 1Ģ621(config-if)# peer default ip address pool testĢ621(config-if)# ip unnumbered FastEthernet0/0Ģ621(config-if)# ppp authentication pap chap ms-chap Cisco 2621 Router 2621# configure terminalĮnter configuration commands, one per line. These IOS commands are applicable to all platforms that support PPTP. Refer to Cisco Technical Tips Conventions for more information on document conventions. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment.
CONNECT TO PPTP VPN MAC COMMAND LINE SOFTWARE
The information in this document is based on the software and hardware versions:Ĭisco 2621 Router that runs Cisco IOS Software Release 12.2 There are no specific requirements for this document.
CONNECT TO PPTP VPN MAC COMMAND LINE WINDOWS
Refer to Configuring Cisco Secure ACS for Windows Router PPTP Authentication for more information on PPTP authentication with Cisco Secure Access Control Server (ACS).
CONNECT TO PPTP VPN MAC COMMAND LINE HOW TO
Note: This configuration will also change your default route to the VPN.This document describes how to configure a Cisco IOS ® router that terminates Windows 2000 Point-to-Point Tunnelling Protocol (PPTP) Clients, and Microsoft Point-to-Point Encryption Protocol (MPPE). Now you only need start the pppd daemon with the following command and that’s it. This file will contain the configuration that pppd daemon will reference and try to connect. The procedure is quite simple, you first need to create a file in /etc/ppp/peers with a name that represent your domain, or company, so in my case I will call it. It’s based on my own configuration ( MPPE-128), so you might have to adapt it to your need. The following procedure will show how you can create a PPTP VPN on macOS Sierra. I know that PPTP VPN has become outdated and is less secure than other protocols, but in a corporate world you sometimes don’t have a choice. Apple stopped the support for it’s builtin PPTP VPN client on macOS Sierra, but they kept their libraries, so it’s still possible to create a PPTP VPN connection over command line without using any 3rd party clients, like FlowVPN or Shimo.
0 kommentar(er)
